How did you zone it? Is this RP/SE?

and yes its RP/SE

First, I zone it as single initiator and target (RPA port 0 zone with SP

port 0), then because its not working, I tried to put everything in one

zone (All RPA port 0 zone with SP port 0) and it still show the same

error.The san switch that I use is DS5100B with fw 6.4.1a.Is the problem

coming from san switch?

Regards

Wan Hasrul Ruzaini B Wan Omar

Systems Engineer, ESI Services

CSC MALAYSIA SDN BHD

CSC Asia Group l Office: + 603 7663 7878 l Handphone: +60136100906 l Fax:

+603 7958 6888 l wwanomar@csc.com l www.csc.com

Please consider the environment before printing this e-mail.

CSC • This is a PRIVATE message. If you are not the intended recipient,

please delete without copying and kindly advise us by e-mail of the

mistake in delivery. NOTE: Regardless of content, this e-mail shall not

operate to bind CSC to any order or other contract unless pursuant to

explicit written agreement or government initiative expressly permitting

the use of e-mail for such purpose • CSC Malaysia Sdn. Bhd • Registered

Office: No.10A Jalan Bersatu 13/4, Section 13, Petaling Jaya 46200,

Selangor Darul Ehsan, Malaysia• Registered in Malaysia No: 25110P

From: Ernes Taljic

To: Wan Hasrul Ruzaini Wan Omar/MYS/CSC@CSC

Date: 12/28/2011 12:34 AM

Subject: New message: "I got an error on SAN

Diagnostics "SAN View is empty, Check zoning and LUN masking""

EMC Community Network

Re: I got an error on SAN Diagnostics "SAN View is empty, Check zoning and

LUN masking"

created by Ernes Taljic in RecoverPoint - View the full discussion

How did you zone it? Is this RP/SE?

Reply to this message by replying to this email -or- go to the message on

ECN

Start a new discussion in RecoverPoint by email or at ECN

Try this. Create one zone with all RPA ports and both CX ports in that zone.

In other words, on switch A, create a zone with rpa1-p0, rpa2-p0, spa0 and spb1 PWWN's. Do the same thing on the other switch (rpa1 p1, rpa2 p1, spa1 and spb0).