Unsolved
This post is more than 5 years old
37 Posts
0
996
RecoverPoint/EX many to one implementation
Hello,
We need to implement a solution where two source VNX arrays (call them VNX1 and VNX2) will replicate to one target VNX array for DR purposes. There are 4 RPAs at source and 2 at target. The initial thought is that we set up VNX1 with 2 of the 4 RPAs paired with target VNX as in a typical RP environment. Once that environment is running, how do we incorporate the VNX2 array? Is it just a matter of running the deployment manager again with the remaining 2 RPAs and VNX2 with target VNX array? Just wondering if this would be managed as two separate environments and if the same target RPAs and array can be part of both.
prashant_shah
37 Posts
0
April 18th, 2013 13:00
We were able to figure this out.
We ended up zoning both arrays to the RPAs and presenting the repository from only one array. After adding splitters from the first array, we second array splitters were not showing up. Went to CLI and scanned for luns. After that did a rescan in the GUI and added the second array splitters.
geolytle
9 Posts
0
May 28th, 2013 12:00
This is now fully supported in Recoverpoint 4.0