Recoverpoint commands and plink

Question

looking to automate the configuration of a few pieces during a VMware SRM excercise.  Anyone with experience with issue commands to RPA using plink? I'm using the following: plink -ssh admin@drrpa.com -pw blahblah-v < 'E:\SRM_SCRIPTS\RPACOMMANDS\RecoverpointUnManage.txt' the tst files contains lines such as: config_external_mgmt group=duane managed_by=EXTERNAL_APPLICATION config_external_mgmt group=duane1 managed_by=EXTERNAL_APPLICATION config_external_mgmt group=duane2 managed_by=EXTERNAL_APPLICATION problem is that while commands seems to execute, plink never officially exits.  if i put a singled command in the file, it works just fine.

forshr · Accepted Answer

You need to add a semi-colon at the end of each command line. Regards, Rich

duhaas1 · Answer

good stuff thanks forshr

RecoverPoint

Was this post helpful?