There is no need for multipathing, as ScaleIO volumes will be presented to the Linux host with a single path anyway - all the load balancing and failover functions are realized "behind the curtain" by the SDC driver - just make sure you have 2 (or more) NICs configured with the IPs from the ranges used in your ScaleIO system, and the software will take of this for you without need of any extra configuration.
From ScaleIO UserGuide:
For Linux devices, the scini device name can change on reboot. It is recommended to mount a mapped volume to the ScaleIO unique ID, a persistent device name, rather than to the scini device name.
To identify the unique ID, run the ls -l /dev/disk/by-id/ command.
Hope that helps - let me know if anything is still unclear!
pawelw1
306 Posts
0
October 23rd, 2016 23:00
Hi Stefan,
There is no need for multipathing, as ScaleIO volumes will be presented to the Linux host with a single path anyway - all the load balancing and failover functions are realized "behind the curtain" by the SDC driver - just make sure you have 2 (or more) NICs configured with the IPs from the ranges used in your ScaleIO system, and the software will take of this for you without need of any extra configuration.
From ScaleIO UserGuide:
For Linux devices, the scini device name can change on reboot. It is recommended to mount a mapped volume to the ScaleIO unique ID, a persistent device name, rather than to the scini device name.
To identify the unique ID, run the ls -l /dev/disk/by-id/ command.
Hope that helps - let me know if anything is still unclear!
Best regards,
Pawel
pawelw1
306 Posts
0
October 23rd, 2016 23:00
BTW, if you need to use a ScaleIO device with DM-MPIO on Linux, here is the procedure:
https://support.emc.com/kb/484523
Pawel