Unsolved
This post is more than 5 years old
2 Posts
0
23312
Dimension 4100 - Windows Xp CD will not Boot
I am currently using a
Dimension 4100 with the operating
BIOS system A04.
However, my problem is that when I go to the BIOS to have the computer boot up from the CD-ROM, it is unable to do so. Therefore, my windows xp cd doesn't load up.
If I update the BIOS to the most current one, will my computer be able to boot from the cd?
I'm not sure if anyone else has this issue.
Predator
15.3K Posts
0
January 5th, 2006 18:00
Hi Daniel,
Just to be sure we are all on the same page, you enter the BIOS and change the boot order to the CD-ROM as first device, Save / Exit. However the PC will not boot from the CD-ROM drive?
Do you have two drives and if so, whci one are you trying to use?
I cannot honestly say that updating the BIOS will correct this because I did not check each update from A05 to A11 to see if this type of issue was a problem and addressed with a BIOS update, something you may wish to consider or just update to A11 and see if it helps.
Best Regards!
God, grant me the senility to forget the people I never liked anyway,
the good fortune to run into the ones I do and the eyesight to tell the
difference.
CD/RW Link
rrogan
5 Posts
0
January 6th, 2006 01:00
I am currently having the same problem with a Dimension 4100
I upgraded the bios to A11, I went into the bios boot setup and made the first device to boot the cdrom but still no go. I swapped out the cdrom with one that works on an other system and it still didn't work so I'm assuming it's the bios. Any suggestions would be deeply appreciated.
osprey4
4 Operator
4 Operator
•
34.2K Posts
0
January 6th, 2006 12:00
To repeat Jeff's question, do you have more than one optical drive and if so, which one are you using? You can only boot from the master ATAPI drive.
If you want to update the BIOS, of course you don't need the CD drive.
rrogan
5 Posts
0
January 6th, 2006 15:00
I only have one optical drive set up as the master on the secondary IDE
I still have the default setup from when I bought it from Dell
osprey4
4 Operator
4 Operator
•
34.2K Posts
0
January 6th, 2006 16:00
rrogan
5 Posts
0
January 6th, 2006 16:00
Osprey,
I've done exactly that. The cd rom's jumper is on cable select.
I went into the bios and made it the first and only bootable drive
osprey4
4 Operator
4 Operator
•
34.2K Posts
0
January 6th, 2006 18:00
So what happens? Are you getting a non-bootable disk message?
Do you have another bootable CD you can try?
rrogan
5 Posts
0
January 6th, 2006 20:00
osprey4
4 Operator
4 Operator
•
34.2K Posts
0
January 6th, 2006 21:00
rrogan
5 Posts
0
January 7th, 2006 21:00
That worked!
Thanks for your help it's much appreciated.
osprey4
4 Operator
4 Operator
•
34.2K Posts
0
January 7th, 2006 23:00