Unsolved
This post is more than 5 years old
4 Posts
0
1863
Device Mapping in ECC vs. CLI
I am trying to get some devices mapped in ECC and am continualy getting an "unable to obtain resources" error. Is there and easier way to do this via CLI? If so, what is the command syntax?
Thanks,
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
0
January 11th, 2012 10:00
see if you have access to this documentation set
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
0
January 11th, 2012 10:00
symmetrix ?
barrett3
4 Posts
0
January 11th, 2012 10:00
Yes. It's A DMX-3. The Primus (emc203344) is not real clear on the syntax.
barrett3
4 Posts
0
January 11th, 2012 13:00
I'm still not very good with the CLI for symmconfigure. Can you tell me where I'm wrong on this syntax?
MAP DEV 813 TO DIR 3b:0 TARGET=096
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
0
January 11th, 2012 14:00
can you tell me how did you come up with this command ? (device , DIR ..etc). Just trying to understand what i need to explain
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
0
January 11th, 2012 14:00
How big of a device do you need to present ? Meta / non meta ?
barrett3
4 Posts
0
January 11th, 2012 14:00
Yeah, I was searching the 7.3 Command reference (we are at 7.3.0) for mapping a device and came accross the following:
Mapping a device to an address, or a range of devices to consecutive addresses specifying a starting address:
map dev [: ]
to dir : ,
[starting] [target= ,] lun=
[, vbus= ]
[, awwn= | wwn= | iscsi= |
aiscsi= ]
[, masking [host_lun= | dynamic_lun] ]
[, emulation=CELERRA_FBA];
seamuscoffey
472 Posts
0
January 12th, 2012 00:00
Hi,
There is no guarantee that the configuration will succeed from SYMCLI. The resources error that you saw in ControlCenter could be as a result of a script that is currently running on the array and/or an issue with the Service Processor. Please see Primus solutions emc98360 & emc253282.
You may need to engage your local EMC Customer Engineer.
Regards,
Seamus Coffey
Worldwide Technical Support - Ionix SRM