I'm looking into this and testing also, but I wanted to see what servers you're working with, so I can use similar platforms. If you could share some of the models and iDRAC revisions, it may be helpful with testing. I don't expect much difference from one platform to the next, but I don't want to dismiss it as a possibility, either.
I haven't been able to find documentation identifying the specific syntax to boot to the LCC by Redfish API, unfortunately. I've looked at all the documentation I can find and I also spoke with some of our System Management support members, but couldn't find anything. There's one other resource I'm going to check today, I'll post another reply if I can get an answer.
Dell-DylanJ
4 Operator
•
2.9K Posts
0
July 16th, 2019 08:00
Hello,
I'm looking into this and testing also, but I wanted to see what servers you're working with, so I can use similar platforms. If you could share some of the models and iDRAC revisions, it may be helpful with testing. I don't expect much difference from one platform to the next, but I don't want to dismiss it as a possibility, either.
np-mast
3 Posts
0
July 17th, 2019 00:00
Hi,
I was using Dell R740(xd)s.
Firmware is 3.32.32.32 and the machines are fresh out of the box.
Dell-DylanJ
4 Operator
•
2.9K Posts
0
July 18th, 2019 07:00
I haven't been able to find documentation identifying the specific syntax to boot to the LCC by Redfish API, unfortunately. I've looked at all the documentation I can find and I also spoke with some of our System Management support members, but couldn't find anything. There's one other resource I'm going to check today, I'll post another reply if I can get an answer.
DELL-Shine K
4 Operator
•
3K Posts
0
July 18th, 2019 08:00
Can you try patch on below URI https://192.168.195.124/redfish/v1/Managers/iDRAC.Embedded.1/Attributes
Body
{"Attributes" : {"ServerBoot.1.FirstBootDevice": "F10"}}