Yes, that's the article I found. I tried the procedure that it stated, and the first line, to enable wbem, seemed to be accepted, but the second one, to start the watchdog, indicated that the service was already running.
After a reboot, there was no change.
As it turned out, I ended up having to rebuild both of my hosts due to updating to 6.7u3 causing huge issues with pretty much everything other than basic machine functioning (vMotion, registering machines, entering/exiting Maintenance Mode, etc). After the rebuild, I installed only the iDRAC Service Module, and after a reboot, it seemed to finally update the hostname in the iDRAC. Some reading suggested that the iSM is a replacement for OpenManage, so perhaps they were conflicting.
Daniel My
10 Elder
•
6.2K Posts
0
September 4th, 2019 15:00
Hello
Enabling CIM should still apply to 6.7, is this the article you found?
https://www.dell.com/support/article/sln306586/
Thanks
DKramkowski
1 Rookie
•
9 Posts
1
September 6th, 2019 09:00
Yes, that's the article I found. I tried the procedure that it stated, and the first line, to enable wbem, seemed to be accepted, but the second one, to start the watchdog, indicated that the service was already running.
After a reboot, there was no change.
As it turned out, I ended up having to rebuild both of my hosts due to updating to 6.7u3 causing huge issues with pretty much everything other than basic machine functioning (vMotion, registering machines, entering/exiting Maintenance Mode, etc). After the rebuild, I installed only the iDRAC Service Module, and after a reboot, it seemed to finally update the hostname in the iDRAC. Some reading suggested that the iSM is a replacement for OpenManage, so perhaps they were conflicting.
Daniel My
10 Elder
•
6.2K Posts
0
September 6th, 2019 12:00
That sounds like a lot of fun, glad you got it sorted.