iDRAC 6 showing incorrect memory configurations for M610

Question

Hello I have a M610 that I upgraded the memory in and both in the CMC webgui and the idrac webgui it shows the old memory configuration and does not recognize that all the memory modules have been replaced with larger ones. I ham having this problem on all my blades as well.

a_pratap_singh · Answer

Hi Rherling,

Thanks for writing to us on the forum, Please try the below scenario for get current memory details....Hope it's helpful :-)

1: Check the system tab screen for memory population. (If you have same observation, than please check and conform the memory population on system)

2: Reset the iDRAC and CMC web-gui of system and check the details.

Thanks,

Amit

Systems Management General

iDRAC 6 showing incorrect memory configurations for M610

Was this post helpful?