Unsolved
This post is more than 5 years old
2 Posts
0
310257
killing iDrac GUI sessions from CLI
Recently on two of my servers, an r710 and an r900, we've had one team member unable to log into the idrac web interface owing to no available sessions. If one logs into the CLI for idrac and runs "getssninfo", you can see it's maxed out with GUI logins from his desktop - sessions are apparently not terminating correctly.
Is there a way to kill unused sessions from the CLI like you can terminate them through the GUI?
DELL-Shine K
4 Operator
4 Operator
•
3K Posts
0
October 22nd, 2013 11:00
For R710 you can run following racadm command to kill sessions
To close on session
racadm closessn –i
To close all open session
racadm closessn -a
For R900 there is no racadm command to close session. You can reset iDRAC using following racadm command to kill all sessions. Resetting RAC will not reboot the server only iDRAC will not be accessible for some time.
racadm racreset
Kumar Prashant
1 Message
0
October 23rd, 2013 04:00
If you are using DTK then you can kill all the session using syscfg.
command is syscfg --racreset.
after giving the command you need to wait for some time.