Highlighted
8 Krypton

uploading and applying license via cli/restapi

Jump to solution
Hi, Does anyone have any experience how to apply the license without the use of initial config wizard. Our aim is to install a system without the use of windows based utilities like initcli, connection utility. The first step of getting the ip is achieved via DHCP, next we would like to have the licenses applied but without the use of GUI. any help, much appreciated. Cheers, Vivek
0 Kudos
1 Solution

Accepted Solutions
Moderator
Moderator

Re: uploading and applying license via cli/restapi

Jump to solution

DHCP for the IP is one way, the other would be to connect to the SPs over IPMI (check docs) and then setup IP with svc_initial_config.

For the license, UEMCLI would be the obvious choice as you have different options for different Operating Systems (doesn't need to be windows).

You can also upload the license file to the system with some scp capable utility, and then setup from within the Unity (uemcli also available there).

You can try RestAPI as well but this may prove too complex.

 

Andre @ Dell EMC
*** If this answered your question, please remember to mark this thread as resolved/answered ***
1 Reply
Moderator
Moderator

Re: uploading and applying license via cli/restapi

Jump to solution

DHCP for the IP is one way, the other would be to connect to the SPs over IPMI (check docs) and then setup IP with svc_initial_config.

For the license, UEMCLI would be the obvious choice as you have different options for different Operating Systems (doesn't need to be windows).

You can also upload the license file to the system with some scp capable utility, and then setup from within the Unity (uemcli also available there).

You can try RestAPI as well but this may prove too complex.

 

Andre @ Dell EMC
*** If this answered your question, please remember to mark this thread as resolved/answered ***