Unsolved
This post is more than 5 years old
2 Intern
•
356 Posts
0
1343
February 4th, 2014 09:00
Configure VNX data mover for iSCSI storage
Hey,
Has anyone setup and configured their VNX pool(s) and data mover as a iSCSI target? I could use some phone support on making sure that this and any other supportive configuration is in place prior to sharing out storage over this protocol. I am not use to the file side of the VNX and could use some help. I found this documentation (http://hippodata.blogspot.com/2013/05/setup-iscsi-storage-on-celerra.html) , but it does not provide the steps for configuring a pool that will support the LUNs that I am guessing iSCSI will use for its filesystem.
Thank you,
0 events found
No Events found!
Rainer_EMC
6 Operator
•
8.6K Posts
0
February 18th, 2014 04:00
Hi,
data mover based ISCSI has been discontinued on the VNX
For providing ISCSI storage you need to use the storage processor based ISCSI implementation.
Rainer
chjatwork
2 Intern
•
356 Posts
0
February 18th, 2014 04:00
\Bump
Roger_Wu
6 Operator
•
4K Posts
0
February 18th, 2014 17:00
You can refer to this video "The comparison of the iSCSI configuration on VNX for File and Block": https://community.emc.com/videos/3828
It's in Chinese but since it's a video, you should be able to learn something from it.
chjatwork
2 Intern
•
356 Posts
0
February 20th, 2014 11:00
Wow, really?! Would you happen to have documentation on this?
Rainer_EMC
6 Operator
•
8.6K Posts
0
February 23rd, 2014 14:00
Hi,
you will not find documentation on data mover based ISCSI on VNX since it is no longer supported.
You can ask your EMC sales team to ask via RPQ for a config exception.
You can use the storage processor based ISCSI instead.
Rainer