You will need to reconfigure the hosts so that they can access the data.You will need to confirm that your host is configured as is listed in the unity install guide for your unity system.
What pertains reconfiguring the host to access data. What are the specific steps. Are they mentioned in any of the EMC Best Practices for Solaris connectivity guide. Does reconfigure means the disk IDs will change when the new Unity LUNs are seen on the Solaris after the SANCopy completion and LUNs presented from Unity to Solaris. What is the document number of 'Unity Install Guide' like docuXXXX or hXXXX/h15093 etc.
DELL-Sam L
Moderator
•
7.8K Posts
1
November 30th, 2020 13:00
Hello Bhuppi1,
Which unity system do you have? Here is a link to the Dell EMC Unity Info Hub that has doc’s and guides on now to install your system.
https://dell.to/2JziszO
Bhuppi1
2 Intern
•
131 Posts
0
November 27th, 2020 09:00
Hello,
If we set the same HLU IDs when presenting the disks on the Unity, will that help in this case.
Please advise.
Thank You.
DELL-Sam L
Moderator
•
7.8K Posts
1
November 30th, 2020 10:00
Hello Bhuppi1,
You will need to reconfigure the hosts so that they can access the data. You will need to confirm that your host is configured as is listed in the unity install guide for your unity system.
Bhuppi1
2 Intern
•
131 Posts
0
November 30th, 2020 11:00
Hi Sam L,
What pertains reconfiguring the host to access data. What are the specific steps. Are they mentioned in any of the EMC Best Practices for Solaris connectivity guide. Does reconfigure means the disk IDs will change when the new Unity LUNs are seen on the Solaris after the SANCopy completion and LUNs presented from Unity to Solaris. What is the document number of 'Unity Install Guide' like docuXXXX or hXXXX/h15093 etc.
Thank You.