Vnx7500 disk layout

Not completely sure I understand all your questions, but the link below provides detailed information about the VNX7500 regarding the number of disks/DAE/Buses supported - it's in Appendix A.

http://https://support.emc.com/docu32529_White-Paper:-Introduction-to-the-VNX-Series-%E2%80%94-VNX5100,-VNX5300,-VNX5500,-VNX5700,-and-VNX7500-.pdf

glen

You can have up to 8 back end bus' (if you have the SAS expander slic). You can have either 15 slot or 25 slot DAE's and you are well under the 1000 drive limit of the array.

How you layout the drives really comes down to your workload requirements, but the vault is always going to be in the first 4 drives of the DPE.

There are lot's of recommendations to follow, most of which can be found in the best practices guide;

https://support.emc.com/docu51389_White_Paper:_VNX_Unified_Best_Practices_for_Performance-VNX_OE_for_Block_5.32_and_File_7.1.pdf?language=en_US

How you configure the drives on the VNX should be in the best way to handle the expected workload the storage environment will put on the array. I'd engage the Professional Services team for better design consultation.

However, for your reference, you can check out documentation like:

https://support.emc.com/docu51389_White-Paper:-VNX-Unified-Best-Practices-for-Performance-VNX-OE-for-Block-5.32-and-File-7.1.pdf?language=en_US

(starting from page 12 in particular)

Adham

I would suggest to start with the hardware installation manual for the 7500 available from support.emc.com or mydocs.emc.com