Unsolved
This post is more than 5 years old
12 Posts
0
621
setup_slot fails
i'm trying to set my secondary CS as primary but the setup_slot -init 0 command is failing saying "Failed to setup, need a mover". i checked the connections between and they look correct. any suggestions or other commands i should try?
./getreason
0 - slot_0 reset
6 - slot_1 control station ready
Vipin VK
812 Posts
0
September 11th, 2013 11:00
is this a PSE recommendation ?
I am not sure of setup_slot with CS, I have used this with DMs only.
icon2000
12 Posts
0
September 11th, 2013 13:00
i don't know if it's recommended but i've used it in the past successfully to manually have the secondary takeover when the primary CS is down. however, if you have to cycle power again you have to manually do the takeover again. anyway, this happened and now it's not working so the nas service never comes up.
The problem i seem to be having is that as soon as the data mover boots up, it causes some alert on my SPA (the amber light on the front disk turns on). not sure what is causing it.
Rainer_EMC
8.6K Posts
0
September 12th, 2013 03:00
Please open a service request and let customer service troubleshoot