If I clicked the "View All Additional Resource" it redirected me to the search page, and after search it shows me only some docs and sizing tool for only hybrid models.
I need sizing tool for All Falsh models, If you have could you share link or send me an e-mail please.
To add to that, if you click on "view additional resources" under "additional resources it comes up with a very irrelevant list of content, the newest being from October 2015 and not related to vxrail.
Any change in the next version of the sizing tool, we can add an "N+x" section? I have had partners asking how we can display N+1, N+2, etc when using the sizing tool. Any chance you could forward this request up?
There is nothing in section 7 that seems to accomplish this. What I mean is up at the top in section 1. It would be nice to select the N+ there and have that calculated against the outputs in section 7.
ColinGallagher
90 Posts
0
May 9th, 2016 13:00
Imminent. It was submitted to the enablement center last week, and should be posted today or tomorrow.
rob_steele
1 Rookie
•
120 Posts
0
May 10th, 2016 05:00
Thanks Colin!
Bill_Leslie
56 Posts
1
May 11th, 2016 15:00
It is posted to the VxRail Enablement Center at the very bottom of the page, in the additional resources section.
https://www.emc.com/auth/rpage/ec-for-vce-vxrail.htm
hssvn
6 Posts
0
May 11th, 2016 15:00
Did you posted Colin ?
If yes, could you share link or name please.
hssvn
6 Posts
0
May 11th, 2016 15:00
Hi Bill, I checked but there are only two docs.
If I clicked the "View All Additional Resource" it redirected me to the search page, and after search it shows me only some docs and sizing tool for only hybrid models.
I need sizing tool for All Falsh models, If you have could you share link or send me an e-mail please.
have a nice day
rob_steele
1 Rookie
•
120 Posts
1
May 11th, 2016 18:00
To add to that, if you click on "view additional resources" under "additional resources it comes up with a very irrelevant list of content, the newest being from October 2015 and not related to vxrail.
jpowellvce
2 Posts
0
May 27th, 2016 06:00
Hi Rob,
Any change in the next version of the sizing tool, we can add an "N+x" section? I have had partners asking how we can display N+1, N+2, etc when using the sizing tool. Any chance you could forward this request up?
rob_steele
1 Rookie
•
120 Posts
0
May 27th, 2016 09:00
The new 3.5 sizing guide has a couple places where you can customize this. Look at section 7, does that help ?
jpowellvce
2 Posts
0
May 28th, 2016 13:00
There is nothing in section 7 that seems to accomplish this. What I mean is up at the top in section 1. It would be nice to select the N+ there and have that calculated against the outputs in section 7.
Thanks!