Unsolved
This post is more than 5 years old
1 Message
0
19524
Wyse Xenith Dual Display Issue
Wyse Xenith Dual Display Issue
Hello Everyone,
I currently have a Wyse Xenith configured with Dual 20" HP widescreen monitors. I purchased the Wyse dual display cable (PN 920302-02L) and have one monitor connected via DVI and one connected via VGA without any adaptors at all.
When initially firing up the station both monitors display properly. When the station goes into power save and turns of the monitors, the secondary monitor doesn't sync properly after coming out of power save mode.
Has anyone else experienced an issue like this before? If so, what did you do to correct the issue?
Regards,
Jason Klingberg
hangulo1
167 Posts
0
June 9th, 2015 06:00
I remember seeing something like this some time back but for me simply powering the monitor off/on would fix the issue
gwest-2015
1 Message
0
June 9th, 2015 06:00
Why doesn't the dual display cable support dual DVI output?
hangulo1
167 Posts
0
June 9th, 2015 06:00
That specific hardware doesnt support Dual Digital output. If you want that you can go with the R10L