I just racked my 2 new DAS's into my existing storage cx4-120. Once i powered on both DAE's i setup the EA for each on of them as the first one 0/1 and second 0/2 for A and B sides. Once done i connected the LCC cables first at A side from exp to primary and again from exp to primary. Same for B side.
i opened NST and run the wizard to install a new hardware the wizard shows found 3 DAS's with 0/0 , 0/1 and 0/2 , clicking to the next page it asking to use address 0/3 in some reason and asking for some reason to install the second DAE with the recommended address 0/3 ??? -
i verified twice EA and cables are setup correctly.

Also when opening navisphere manager it's shows DAE 0/2 with the symbol F. the first DAE detected successfully. Also when opening the disk section under physical shows E symbol for each disk

Any reason why i have this issue?
tx for any help