UNSOLVED
Failover excercise
Hi,
We're planning for failover test , will discard data change at R2 side after completion of DR drill.
Can we use the following commands?
symrdf -g grp failover ; Begin failover
symrdf -g grp establish ; to enable production after test
Thanks.
We're planning for failover test , will discard data change at R2 side after completion of DR drill.
Can we use the following commands?
symrdf -g grp failover ; Begin failover
symrdf -g grp establish ; to enable production after test
Thanks.
974
0
Posted November 3rd, 2009 12:00
I do not think you will be able to run establish in failedover state.974
0
Posted November 3rd, 2009 12:00
Majid,
Thanks for the reply.
We don't want prod to be available during dr test.
Are you saying I have both options - failover & split would work? Can I do just establish to discard data at r2?
Thanks.974
0
Posted November 4th, 2009 01:00
By fail over R1 become WD (prod down)and R2 become RW. By split u cna get R2 RW at the same R1/PROD still available.974
0
Posted November 4th, 2009 11:00
Probably you can RW enable R1 devices, WD R2 devices and issue an establish.
A few more commands, but addresses the issue974
0
Posted October 30th, 2012 08:00
Was this ever answered I'm looking at a similar plan that has been created by somebody else.
I've never used Establish after a Failover before.
EMC Solution Enabler Symmetrix SRDF Family CLI Version 7.3 Product Guide states that a control option Establish is valid against FailedOver device with the caveat that e. Source is not visible to any host.
Does anybody have any experience running this?
The establish should copy the data from the R1 to the R2 and putting the source and target devices back to the pre-test state and discarding any changes made to the R2 whilst it was failed over.
majid7861
18 Posts
974
1
Posted November 3rd, 2009 10:00
- Majid