I would like to help with a backup that is a 56 GB when it comes to it will start doing it IDEX reconnect and start again a new backup. The following error message below.
The error seems to indicate abort has been sent to backup job. This could be due to:
- manual abort
- network issue
- client side issue
If this is happening all the time, can you check if it fails each time for this saveset after same amount of time? Also, since this is Windows box which tends to be VSS unfriendly sometimes, try to limit client parallelism to 1 and see if that makes any difference. I have seen Quit signal errors on some Windows boxes using VSS HW provider by storage arrays and you have to limit parallelism to 1 in such case (but even then you may get this if storage array snapshot is performed if intergrated with VSS and colliding with backup from your side).
ble1
6 Operator
•
14354 Posts
•
56186 Points
976
0
Posted October 24th, 2011 12:00
The error seems to indicate abort has been sent to backup job. This could be due to:
- manual abort
- network issue
- client side issue
If this is happening all the time, can you check if it fails each time for this saveset after same amount of time? Also, since this is Windows box which tends to be VSS unfriendly sometimes, try to limit client parallelism to 1 and see if that makes any difference. I have seen Quit signal errors on some Windows boxes using VSS HW provider by storage arrays and you have to limit parallelism to 1 in such case (but even then you may get this if storage array snapshot is performed if intergrated with VSS and colliding with backup from your side).