UNSOLVED
Management VLAN
Hello,
I'm a bit confused with VLANs. Sorry about that.
I have a FX2 with 3 FC630 running ESXi and 2 FN410T as IOM. Uplink is a S4820T.
On the S4820T I use VLAN 1 as in the FN410T all ports are in this VLAN untagged. For iSCSI i use other VLANs.
My question what I don't understand is now the Management VLAN. Can I use a VLAN wich is not the Default-VLAN for the Management-Interfaces and can I mix Tagged and Untagged ports? This is necessary in my opinion because I want to use the same port of the router. This would than mean that the router has the default-VLAN for user-traffic and another VLAN for management. But the Management-Interface cannot bound to a VLAN. Now I'm stuck.
Thx in advance
Willi2793
32 Posts
4882
0
Posted August 15th, 2017 08:00
I think I understand a bit more and I'm one step closer to the solution.
Now I have a router wich is the gateway for the User-Traffic without VLAN. It has a Subinterface for VLAN 157 and a different subnet for management. Routing on the Router seems okay (it's a Juniper Firewall Device). But I cannot ping the management-address of the connected Switch. I also tried to configure a management-route with no success.
Here are the interfaces of the Switch:
interface TenGigabitEthernet 0/28
no ip address
portmode hybrid
switchport
speed 100
no shutdown
!
interface TenGigabitEthernet 0/29
no ip address
portmode hybrid
switchport
speed 100
no shutdown
!
interface ManagementEthernet 0/0
ip address 192.168.152.243/24
no shutdown
!
interface Vlan 152
no ip address
tagged TenGigabitEthernet 0/28-29
shutdown
!
Are there any other things I have to think about? User-Traffic is coming fine thru the Switch.