Announcement Banner

LPick

updated

7 years ago

L

LPick

1 Rookie

•

7 Posts

0

1713

December 6th, 2019 10:00

Emulex firmware update fail

Hello,

Thanks for any help with this.

I'm using Lifecycle Controller to update firmware. It's worked well so far but i cannot get the Emulex card to update.

It's stuck on 02.00.04

I've disconnected the storage from the controller and rebooted and re-tried to upgrade a few times.

Anyone had this problem and resolved it? detailed error below.

Also, is anyone updating firmware for the power supply or CPLD? i don't think it was listed in the scan and update firmware wizard.

Many thanks,

I get the following error: 

Event Message: Communication with Integrated RAID Controller 1 is intermittent.
Date/Time: Fri, 06 Dec 2019 16:07:05 -0600
Severity: Critical

Detailed Description: The controller is not receiving a consistent response from the enclosure. There could be a firmware problem or an invalid cabling configuration. If the cables are too long, they degrade the signal.
Recommended Action: Power down all enclosures attached to the system and reboot . If the problem persists, upgrade the firmware to the latest supported version. Verify the cable configuration is valid. See the storage hardware documentation for valid cabling configurations.
Message ID: ENC24

System Model: PowerEdge R730