I am upgrading the hardware from Gen1 to Gen4.  I have already downgraded the software on the Gen4 appliances to 3.2 SP4 so it matches the Gen1 appliances.  I will be using the RPA Replacement Wizard.  I have a couple of questions:

1. Can I create a configuration file from the exisitng configuration for use or do I have to start with a blank configuration file and enter settings
2. The instructions say before disconnecting mark the orieintation of the network and fibre channel cables.  Then connect in the same configuration. Gen1 applainces are (2) dual port HBAs, Gen4 are a quad port HBA.   The Wan and LAn are asy they are identified but:
   • How do I map the dual port configuration to the quad port configuration?
   • Does it matter since the WWNs are spoofed?

thanx