How to use remote KVM feature of DRAC 4/P PCI card on non-Dell server?

 

I'm building low-end home server based on ASUS P5B-E (Intel 965 chipset), Intel Core 2 Duo 6300 and Linux. I tried to install DRAC in different  PCI slots with about the same effect. VGA part of DRAC works fine. At boot time BIOS show additional message "Sil 0680 ATA/133 Controller BIOS Version 3.4.1027". NIC ethernet link goes up at 10 Mb/s.

 

In Linux after installing DRAC i see 3 additional PCI devices (lspci -nn):

05:02.0 PCI bridge [0604]: Hint Corp HiNT HB4 PCI-PCI Bridge (PCI6150) [3388:0022] (rev 04)
06:02.0 VGA compatible controller [0300]: ATI Technologies Inc Radeon RV100 QY [Radeon 7000/VE] [1002:5159]
06:07.0 IDE interface [0101]: Silicon Image, Inc. PCI0680 Ultra ATA-133 Host Controller [1095:0680] (rev 02)

 

But i can not enter DRAC setup utility (ctrl-d does nothing at boot time) and i can not access web gui on default DRAC IP (192.168.0.120). There are no any network activity on DRAC NIC. No ARP requests/replyes, no DHCP, no any other packets...

 

How can i set DRAC configuration in my case?

What is the pinout for "mgmt cable" connector? Can i set DRAC config by connecting RS232 terminal or something to this connector?

 

 

Regards

Mikle