Hi!

1) You can find out the model of array with "getagent -model":

naviseccli -h A_APM00072802071 getagent -model

Model:               CX3-80

You can also get the FLARE code version with "getagent -rev":

naviseccli -h A_APM00072802071 getagent -rev

Revision:            3.26.80.5.031

In this output, my CX3-80 is running FLARE 26

2) Try naviseccli snapview -listsessions -cacheusage or just snapview -listsessions -all - you'll get a lot of data on your snapshot session

3) I doubt you can remove this snapshot.  This one is taken automatically, so that you can rollback the state.

Let us know if this helps!

Karl

Thanks Karl :-)

getagent works for me.

but is there another way to see the snapshot size without snapview?

snapview in not enabled on my system:

# /opt/Navisphere/bin/naviseccli -h xxx.xxx.xxx.xxx snapview -listsessions -all

This version of Core Software does not support Snapview

Thanks

liav

Since you do not have the SnapView license you have to mask out all but the reserved snapshots and reserved sessions used by layered applications such as MirrorView/A (and SAN Copy) from your output, so you can't use "-all".

Instead, use "-reserved" as follows:

naviseccli -h snapview -listsessions -reserved

naviseccli -h snapview -listsnapshots -reserved