Unsolved
This post is more than 5 years old
2 Posts
0
1759
August 6th, 2018 18:00
Macro Delay not working properly on AW568 in Command Center
The delay function in macros doesn't appear to have a delay duration anywhere near as long as I've specified. I'm attempting to have a delay for multiple seconds, but the actual delay when I execute the macro is much much shorter.
To confirm my issue, I attempted a simple test with a new macro to have a sequence of numbers appear with a gap of three seconds introduced between each number appearance. Each time the next number appeared in less than 1 second of the previous.
When I open up the macro to edit it, it does say three seconds as the delay. I didn't have this issue with the AW Control Center.
Thoughts and suggestion appreciated in advance!
No Events found!
Bradleyjs2
1 Rookie
•
28 Posts
0
August 7th, 2018 12:00
Just curious, are you using the latest AW Command Center - Version: 5.2.0.0 ,A00 - Release Date: 31 Jul 2018? Also, is the keyboard’s firmware up to date?
XeroSilver
2 Posts
0
August 7th, 2018 13:00
Thanks for the response.
Yes, all up to date on the software and keyboard firmware versions.
I have found that a unit of 5 in the delay variable equals 1 second.
10 delay units gives me 2 seconds of delay.
50 delay units gives me 10 seconds of delay.
So I have a work around, but it's not obvious.
Bradleyjs2
1 Rookie
•
28 Posts
0
August 8th, 2018 04:00
Ok, sounds good!