First, I'm assuming you mean File level Recovery (FLR), since GLR is not a term used with vmWare backups.
When the Avamar Admin GUI starts an FLR session, it dedicates a proxy session to capture the vm credentials, and will not change that until the end of the proxy session.
So - the way to change vm credentials is to close / logout from the Avamar Admin GUI, then log back in.
Alternatively, open a new Avamar admin GUI instance.
I was referring to the Granular Restore option for VMware guests from within Avamar.
Here is an example I am running into. I just tried to restore a folder from a Linux VMware guest machine. Once I started the job it ran for about 45 minutes and had not done anything. I looked at the log and found this error in red 'avvmwfile Error <0000>:' a few lines above this error in the log was this warning: avvmwfile Warning <6788>: Found unknown section 'browse-from-catalog' in workorder, ignoring' So I canceled the job. Tried to run the restore again by browsing to the guest, clicking on the Granular Restore option, and eventually got a pop up that says 'Failed to generate session handle'. I assume when I use the Granular Restore option that Avamar must index the data from the vmdk's and populates the restore listing, when I close out and try to use the Granular Restore again there is some sort of cache left behind and causes the error? Similar with my first post, the next day I would be able to try the restore again and not receive the pop up error.
I have already done what was suggested, as in closing out of the Avamar GUI and getting back in to get past the credential issue and I still receive that error until the next day after the garbage collection runs.
pawankumawat
355 Posts
0
June 9th, 2014 02:00
Hello,
I would suggest to open a service request with EMC support.
Regards,
Pawan
Vijay__Avamar_
16 Posts
0
June 10th, 2014 14:00
First, I'm assuming you mean File level Recovery (FLR), since GLR is not a term used with vmWare backups.
When the Avamar Admin GUI starts an FLR session, it dedicates a proxy session to capture the vm credentials, and will not change that until the end of the proxy session.
So - the way to change vm credentials is to close / logout from the Avamar Admin GUI, then log back in.
Alternatively, open a new Avamar admin GUI instance.
Anonymous User
1 Rookie
•
55 Posts
0
July 16th, 2014 14:00
I was referring to the Granular Restore option for VMware guests from within Avamar.
Here is an example I am running into. I just tried to restore a folder from a Linux VMware guest machine. Once I started the job it ran for about 45 minutes and had not done anything. I looked at the log and found this error in red 'avvmwfile Error <0000>:' a few lines above this error in the log was this warning: avvmwfile Warning <6788>: Found unknown section 'browse-from-catalog' in workorder, ignoring' So I canceled the job. Tried to run the restore again by browsing to the guest, clicking on the Granular Restore option, and eventually got a pop up that says 'Failed to generate session handle'. I assume when I use the Granular Restore option that Avamar must index the data from the vmdk's and populates the restore listing, when I close out and try to use the Granular Restore again there is some sort of cache left behind and causes the error? Similar with my first post, the next day I would be able to try the restore again and not receive the pop up error.
I have already done what was suggested, as in closing out of the Avamar GUI and getting back in to get past the credential issue and I still receive that error until the next day after the garbage collection runs.