Celerra datamover CPU and memory monitoring using SNMP

And how do you integrate that with MRTG ?

I apoligize, but we do not have any documentation on integrating this with MRTG.  I would recommend engaging the MRTG vendor for assistance with configuring their product with different devices.

Thank you.

- Sebby Robles

Please refer to the attached document to configure events and notifications.  You will see a table with events towards the end of the document.

- Sebby Robles

* If this post was able to help or resolve your question, please take a moment to rate it.  Thank you. *

hehe..it's open source product.

It's not a question about MRTG but SNMP. Can the datamovers provide CPU and memory utilization over SNMP ?

i asked the same question a while back

https://community.emc.com/thread/105616?tstart=30

Hi,

as you've seen in the snmpwalk the data mover CPU and memory isnt implemented in the data mover SNMP agent.

Please take a minute and let EMC product management know via Product Enhancement Request (Powerlink) that this should be enhanced.

You might be able to hack the control station snmpd to call the CLI and get the info that way or get MRTG to ssh into the Celerra or get the info via XML

Rainer

Rainer,

I will test collecting via XML, how CPU intensive is the XML collect process? I this something I can run every 5 minutes without major impact on the control station ?

Sorry – no idea

I don’t think 5 minutes is a problem though

Let us know how you did it

Rainer

Dynamox,

I just read your post. Did you ever implement CPU and Memory graphing with MRTG ?