Hello,

Does anybody know how to do fresh install on Celerra NS20 system?

Powerlink has no suchinformation in documentation.

After installing Linux Station 1.0 setup is trying to complete NAS installation but it always fails.

I'm using Intergated mode.

Both options for Fiberchannel support give different errors.

If I select Fiberchannel "enabled" I got error on searching existing RG/LUN:

Backend backup server not found.

If I select Fiberchannel "disabled" I got error on setup Enclosure step:

===============================================================================                         Starting EMC NAS Factory Installation =============================================================================== Setting up the Enclosure... ERROR setting up the enclosure... Executing -initSystem option force mode Initialize all system Enclosures Begin ... Create initial ENCL_DB & DHCPD_CFG ... OK Examine DHCPD_CFG Perform initial Mgmtswitch broadcast reset for Primary Subnet .....Cannot detect any Mgmtswitch in this subnet Perform initial Mgmtswitch broadcast reset for Secondary Subnet .....Cannot detect any Mgmtswitch in this subnet Perform initial system discovery ............. Discover 0 Mgmtswitches in Primary subnet A, 0 Mgmtswitches in Secondary subnet B Cannot find any Mgmtswitch in this system Error: resetMgmtswitches FAIL (EDISCOVER) Error: initSystem FAIL (EDISCOVER) Error: INITSYSTEM_CMD retval = -4 (EDISCOVER)

I tried to run setups from cdrom:

sh nas_install can be running only 1 time and gives error:

Disabling crond... crond is stopped ## Executing preinstall script. emcnas Package Install... Continuing with the "emcnas" install... Creating the NAS Partition on /dev/nde1 with fdisk... ERROR: Could not create the NAS Partition on /dev/nde1 Execution of preinstall script failed /bin/emcrpm: Error: /mnt/source/EMC/nas/emcnas-5.5.31-6.i386.rpm install failed

Other attemps to run sh nas_install gives errors:

Unable to rebuild emcnas database

2nd setup is sh S95nas. It tries setup Enclosure and gives errors listed above or the following:

===============================================================================                         Starting EMC NAS Factory Installation =============================================================================== Setting up the Enclosure... ERROR setting up the enclosure... Executing -initSystem option force mode Initialize all system Enclosures Begin ... Create initial ENCL_DB & DHCPD_CFG ... OK Error: DHCPD fail to start.  Check /var/log/messages Error: initConfig FAIL (EDHCPD) Error: initSystem FAIL (EDHCPD) *** Error detected, Start restoring original ENCL_DB & DHCPD_CFG ... Remove Dynamic IP range in DHCPD_CFG ... OK Restart DHCPD with updated DHCPD_CFG ... Error: DHCPD fail to start.  Check /var/log/messages Error: Unable to remove Dynamic IP Range in DHCPD_CFG Error: INITSYSTEM_CMD retval = -28 (EDHCPD)