Unsolved
This post is more than 5 years old
3 Posts
0
726
August 26th, 2008 02:00
How to get CS IP address?
I just received a NS20 that was already configured by some other department. But unfortunately nobody know the IP address of the control station. Is there any way to get the IP address with either console or CSA?
I also tried login into CS BIOS but found it was set password.
Many thanks
I also tried login into CS BIOS but found it was set password.
Many thanks
No Events found!
Rainer_EMC
6 Operator
•
8.6K Posts
0
August 26th, 2008 02:00
then login and do a "/sbin/ifconfig eth3" to see what the address is
Instructions to connect:
a. Connect a null-modem serial cable from the serial port on the
front of the Control Station to your service laptop.
b. On the service laptop, open a HyperTerminal session using the
serial port connected to the Control Station. Set the
HyperTerminal connection to 19200 bits per second, 8 data
bits, parity none, 1 stop bit, and Hardware flow control. Set
terminal emulation to ANSI. Use the default values for all
other settings.
sagle
90 Posts
0
August 26th, 2008 08:00
User: nasadmin
Pass: nasadmin
That is the default, but most likely has been changed since install.
Jack623
3 Posts
0
August 26th, 2008 08:00
is there any default username and password when login to the console?