NS600 and Celerra Replicator

Question

We have a new NS80 with Replicator V2 enabled and licensed: nasadmin@ohcinnascs07 ~]$ /nas/sbin/deploy_replication -status -verbose 'replicatorV2' license is enabled. [nasadmin@ohcinnascs07 ~]$ Per the Replicator V2 guide, the NS600 is not supported with Replicator V2. Also, since we are ''replicatorV2' license is enabled' on our NS80, we apparently cannot change the Replicator mode on the NS80 to V1. At least that's what I got out of the Celerra Replicatorr V2 pdf. can someone confirm if I can or cannot use Replicator with our NS600? Thanks. Jim

Peter_EMC · Accepted Answer

NS600 is not supported with NAS 5.6 and therefore unable to do Replicator V2.

But anyway. If your NS80 is using Replicator V2 then it is running NAS 5.6
Replication between different NAS families (like between 5.5 and 5.6) is also not supported.

NS600 (NAS 5.5) can only use Replicator V1

Rainer_EMC · Answer

you can use Replicator V1 on the NS600 running DART 5.5 but not Replicator V2 since that requires DART 5.6you can try to talk to your EMC TC about a RPQ

jimkunysz · Answer

Thanks. So I understood the pdf correctly.I do appreciate the fast (and knowledgeable) responses!btw - I heard there is a ndmp copy capability for migrating a filesystem?Message was edited by: Jimbo

Celerra

Was this post helpful?