Being put off after reading posts stating there are space issues when fitting a Corsair water cooler, I finally bit the bullet and had a go yesterday. So some tips to anyone else attempting it. Ensure you have the service manual at hand and there is a good video on how to take the casing apart, makes it look far easier than it is. I prised the left side panel off using a pair if cutlery knives fitting in the gap near tabs, 2 needed as the blade on one would flex. The top cover is two parts, make sure you don't remove the very top cover (the shiny black one as opposed to matte cover with the handle) by mistake as I did, this ended up breaking 2 of the 4 tabs trying to refit it .... but would not have happened if the complete cover was removed, as there would be access to pop the tabs in from underneath, oh well :( The rest is pretty straightforward, don't forget to press the power supply test button which discharges the supply. The hoses are reasonably flexible and the optimum position I found to avoid stress on the cooler pump and other components when the power supply unit is closed is as below. where's the attach photo option gone?

Any picture has to be approved by a moderator before they show up on the forum. By tomorrow it should be displayed as this is a weekend.

‎Centera Viewer User guide | DELL Technologies

UNSOLVED

Kasbe_Prashant

updated

16 years ago

Kasbe_Prashant

1 Rookie

•

70 Posts

12039

July 5th, 2010 21:00

Hi,

I'm looking for some help on using Centera Viewer tool.

I'm writing one code which will import contents into Centera and set few custom atrributes, for cross verifying I need to see the attributes.

Can anyone guide me through how to use CenteraViewer tool, I believe this tool is like an interface to view Centera contents.

Please revert with your experience and knowledge.

Thanks in Advance

Prashant