You can consolidate the two cubes into one rack. You can move cube 5 into the same rack as cube 2, however you cannot move the nodes from cube 5 (c005n01 to c005n06) into cube 2's "empty" positions. The cube interconnections would be on ports 19/20.
If there is space available you could do another CICM. Please remember that you cannot perform a CICM and then add those nodes back into the same cluster. If another cluster (DR site) is available you could move those nodes that have undergone a CICM and been reinitialized into that cluster.
I have two Centeras with the same situation. So I can do a CICM and use the nodes from one cluster to add it to the other cluster. (swap the nodes between clusters).
But, why I can't use the empty positions of Cube2? If I attach the nodes to the correct Switch ports, cluster must detect the new nodes in this positions right? Or the removed positions of old nodes will be empty forever?
GBcentera
46 Posts
0
January 19th, 2014 07:00
Yes you can follow the procedures to erase and reload the node and move to another cluster.
You can use the empty positions in Cube 2 - just not with the nodes that have been removed from any location in the same cluster.
GBcentera
46 Posts
1
January 16th, 2014 04:00
You can consolidate the two cubes into one rack. You can move cube 5 into the same rack as cube 2, however you cannot move the nodes from cube 5 (c005n01 to c005n06) into cube 2's "empty" positions. The cube interconnections would be on ports 19/20.
If there is space available you could do another CICM. Please remember that you cannot perform a CICM and then add those nodes back into the same cluster. If another cluster (DR site) is available you could move those nodes that have undergone a CICM and been reinitialized into that cluster.
Dr.diSousa
1 Rookie
•
97 Posts
0
January 19th, 2014 07:00
Ok.
I have two Centeras with the same situation. So I can do a CICM and use the nodes from one cluster to add it to the other cluster. (swap the nodes between clusters).
But, why I can't use the empty positions of Cube2? If I attach the nodes to the correct Switch ports, cluster must detect the new nodes in this positions right? Or the removed positions of old nodes will be empty forever?
Thanks in advance,
Dr.diSousa
1 Rookie
•
97 Posts
0
January 21st, 2014 04:00
Great! Thanks for your help.
Dario
IPM