1. Right click on clariion array and check the connectivity status whether the initiators are showing. If it is showing check whether the initiators are logged in.
2. If it is showing under connectivity status and registered status showing "NO" then you need to install Agent or else you need to register it manually.
3. If it is Registered and not logged in then you need to check the Zoning side and physical connectivity.
4. if the host initiators are not showing under connectivity status at all then you need check the zoning and physical connectivity. If possible remove the zone and create it back. Once you create the zone dont forget to Enable and Save the config. After this just refresh it.
5. Once all these tasks are fine then you can login to Navisphere and update the array once. Update is over then you can go to connectivity status and check.
THis was a little of two issues. The first being that I did the zoning at 2AM sleepy and forgot to enable the config. The second being that there are three hosts that have firewalls between thm and the SAN. Thanks all.
Roops1
18 Posts
0
September 22nd, 2010 21:00
Follow the below steps to check.
1. Right click on clariion array and check the connectivity status whether the initiators are showing. If it is showing check whether the initiators are logged in.
2. If it is showing under connectivity status and registered status showing "NO" then you need to install Agent or else you need to register it manually.
3. If it is Registered and not logged in then you need to check the Zoning side and physical connectivity.
4. if the host initiators are not showing under connectivity status at all then you need check the zoning and physical connectivity. If possible remove the zone and create it back. Once you create the zone dont forget to Enable and Save the config. After this just refresh it.
5. Once all these tasks are fine then you can login to Navisphere and update the array once. Update is over then you can go to connectivity status and check.
Please mark it Answered if this helps.
Parks2
116 Posts
0
September 22nd, 2010 18:00
Did you upgrade the agent on the hosts ? To Release 28,29,30
tkjoffs
159 Posts
0
September 22nd, 2010 18:00
They are Unisphere Host agents, newest version.
Parks2
116 Posts
1
September 22nd, 2010 19:00
At this time I would open a call with EMC Support ....
hersh1
197 Posts
1
September 23rd, 2010 09:00
Any firewalls in play here?
tkjoffs
159 Posts
0
September 23rd, 2010 16:00
THis was a little of two issues. The first being that I did the zoning at 2AM sleepy and forgot to enable the config. The second being that there are three hosts that have firewalls between thm and the SAN. Thanks all.