I'm glad you like the support forum and I hope to maintain the quality you found with my answer .

NaviSphere Server Utility software will guide you to the necessary steps for registering your host correctly .

You need to install this utility on each node and run the setup .

Please refer to the following document "EMC CLARiiON iSCSI Server Setup
Guide for Windows"

http://www.emc.com/microsites/clariion-support/pdf/300-003-805.pdf

Also we have an entire website dedicate to the AX4-5 here you can find all the supported configuration , documents and software for your AX4-5 platform below you can find the address :

www.emc.com/ax4-5support

Regards
Pierluca

Pierluca,

Thanks for that lead. Believe me, I've been searching many times and I never saw that document you provided in your reply. Perhaps my "searching" skills need some practice?

Best Regards,

-MM

Pierluca,

Hello again. With the document you recommended I started over with fresh OS installs, etc. I followed the instructions and I think the install is fine. But, Now I'm back to my original question:

In Navisphere Express: How do I assign the new connections to the Virtual Disk I have created?

1. Do I select all the new Connections and then "Modify" them collectively giving them the one name? Then log into each Windows Server and run diskmgmt.msc and then assign drive letter?

2. Do I just add each server connection one at a time to the Virtual Disk and then log back into the Windows Servers and assign the drive letter?

3. Something else?

Thanks,
-MM

For assign the disk to your server you need to follow this steps in NaviSphere express :

- Select your virtual disk
- click on assign the server (if you not see your server name you need to run the NaviSphere Server Utility on each node )
- select the two cluster nodes
- Now the disk is visible from the two nodes
- Follow the normal microsoft cluster installation steps

regards
Pierluca

This project was successful, many thanks for your help!!!