Solved!
Go to SolutionC class blade enclosure
We have built 2 fabrics both connected to c class blade enclosures. We enabled npv on the 9124's and npiv in the edge switch. Still the cisco port wwn shows up the the flogi not the hba wwn of the blade enclosure. We are using soft zoning.
I need to do the zoning of the blade enclosures to DMX-4's.
Does any one know what could be the issue.
Message was edited by:
nandamuri
I need to do the zoning of the blade enclosures to DMX-4's.
Does any one know what could be the issue.
Message was edited by:
nandamuri
ConnectrixHelpe
259 Posts
376
0
Posted September 8th, 2008 10:00
What version of SAN-OS are you using on the switches and what version of FM are you using?
Thank you.ConnectrixHelpe
259 Posts
376
0
Posted September 8th, 2008 10:00
This is noted in the EMC release notes for 3.2(3a).
The Cisco MDS 9124 switch with SAN-OS Release 3.2(3a) is not supported as a NPIV capable switch with Hewlett Packard¿s Virtual Channel Fibre Channel (VC-FC) blade server modules.ConnectrixHelpe
259 Posts
376
0
Posted September 8th, 2008 10:00
Thank you for the information. Are you using Hewlett Packard¿s Virtual
Channel Fibre Channel (VC-FC) blade server modules?
Thank you.
healyj
141 Posts
376
0
Posted November 28th, 2017 06:00
Hi there,
In our effort s to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we set it to “answered.”
Regards,
Jim