Unsolved
1 Rookie
•
78 Posts
0
267
December 13th, 2021 08:00
Template deployment stopped working
I created a template by cloning a reference device that configures the idrac and deploys the OS. The task has worked perfectly to deploy over 90 new servers but suddenly it has stopped. The idrac gets configured, the static address for idrac is configured and the drac is renamed but when it normally reboots and attaches the system partition to boot to os it simply powers off and won't power back on. If I power the system back on through the idrac system viewer it won't attach the system partition.
No Events found!
Dell-DylanJ
4 Operator
•
2.9K Posts
0
December 13th, 2021 15:00
Hello,
I would have to recommend confirming that you are using the latest version of the appliance and that the target host is on the latest iDRAC firmware. You might also see if a new template works, even if just as a test.
What troubleshooting steps have been tried?
DELL-Erman O
Moderator
•
2.9K Posts
0
December 14th, 2021 05:00
Hi,
Could you please share the warning you see in the log and Do iDRACs have Enterprise licenses?
robwevans
1 Rookie
•
78 Posts
0
December 14th, 2021 05:00
Yes, both the appliance and the target host have been updated. Looking at the log for the failed deployment I'm now getting an invalid attribute under pmlicensing that is causing an error and I think that is stopping the process. Unfortunately I can't edit the existing template to exclude that attribute or exclude it by cloning an existing device to create a new template.