can you describe your setup with more detail please? How the system is connected up to a network? where your workstation is located (loca/remote)? What you're doing to connect? etc. etc. thanks.
the system is connected through CMC . and i can get the server locally and remotely via " CMC , CLI , KVM .....etc"
but any small configuration i did it through CMC failed. for example i tried to configure power supply redundancy to "AC redundancy" or "power redundancy" and active dynamic management . it prompt to me " operation successful" ,but nothing is done .
and tried to give CMC a static ip but doesn't work even after reset it via " racreset command " through KVM console .
I'm not sure what the trouble is, but I think Kumaran is right, you should put this question in the PowerEdge General hardware forum at http://en.community.dell.com/support-forums/servers/f/956.aspx - you'll get your problem answered more quickly there.
Dell-Kumaran P
42 Posts
0
September 9th, 2013 08:00
Azaer,
Please post your query in the PowerEdge General HW forum to get a quick response.
The forum link is here:
http://en.community.dell.com/support-forums/servers/f/956.aspx
Dell - John Abrams
4 Posts
0
September 9th, 2013 10:00
can you describe your setup with more detail please? How the system is connected up to a network? where your workstation is located (loca/remote)? What you're doing to connect? etc. etc. thanks.
azaer
13 Posts
0
September 10th, 2013 01:00
Hi john ..
the system is connected through CMC . and i can get the server locally and remotely via " CMC , CLI , KVM .....etc"
but any small configuration i did it through CMC failed. for example i tried to configure power supply redundancy to "AC redundancy" or "power redundancy" and active dynamic management . it prompt to me " operation successful" ,but nothing is done .
and tried to give CMC a static ip but doesn't work even after reset it via " racreset command " through KVM console .
i don't what what the problem with this server!!!
sorry for not good English
Dell - John Abrams
4 Posts
0
September 10th, 2013 07:00
Azaer,
I'm not sure what the trouble is, but I think Kumaran is right, you should put this question in the PowerEdge General hardware forum at http://en.community.dell.com/support-forums/servers/f/956.aspx - you'll get your problem answered more quickly there.