Thank you for this - so the primary is the one with the older firmware.. how do i force it to make the cm with the higher firmware the active one? That's where I'm stuck.. I can't issue the mem sel commands on the currently active controller because it keeps fighting me saying its not setup.
Nevermind, I came back to the console, it had rebooted and forced the other card to be primary, and everything came back.. all is good now! Thank you! Even both controllers are showing the correct firmware versions at the most up to date.
How far up can I go on these arrays for software versions? Is 7.1.2 the highest?
caseyjpsd
6 Posts
0
March 1st, 2017 13:00
Hi,
Thank you for this - so the primary is the one with the older firmware.. how do i force it to make the cm with the higher firmware the active one? That's where I'm stuck.. I can't issue the mem sel commands on the currently active controller because it keeps fighting me saying its not setup.
caseyjpsd
6 Posts
0
March 2nd, 2017 14:00
Nevermind, I came back to the console, it had rebooted and forced the other card to be primary, and everything came back.. all is good now! Thank you! Even both controllers are showing the correct firmware versions at the most up to date.
How far up can I go on these arrays for software versions? Is 7.1.2 the highest?
caseyjpsd
6 Posts
0
March 2nd, 2017 14:00
Don,
I did a copy of the active primary/lower to the passive and received this error when I booted up...
The nvram version currently running on the array does not match
the version saved in nvram.
Current version: 16
Saved version: 12
This situation can occur if the array experienced an abnormal shutdown
during a firmware update. Contact your customer support provider for
instructions on how to proceed.
The array has been halted.
You can safely power off the array or type any key to restart the array.
Now what do I do?