alert --- Volume not ready

Question

today we got an alert for one of remote standard symmetrix device , saying volume not ready warning ..i know remote devices should be of WD state, but not this not ready state , so do i need to rectify this ?? ( like change that status to ready ) , actully we are not using remote standard devices,may be for every 2 months we do some failover and failback tests to test those devices.. Remote control host is windows box ..where the DR ( srdf device group ) log files are located in windows..like in aix : /usr/emc/DR/logs thank you, -Pctech

dynamox · Accepted Answer

i would post this issue in ECC forum ...there are ECC experts who can help you with that

dynamox · Answer

do you have BRBCVs at the remote site ? Those well go Not Ready when they are established. Or maybe unprotected BCVs when disk failure occurs.

pctech321 · Answer

thankx ..i do..

pctech321 · Answer

Right , we have BRBCVs ..i have another critical error saying symmtrix XXXX: KB/sec read is 84970.546218whats that number means i/o activity per some unit of time ( sec /min ) ..i have whole bunch of alerts and i go through each of them , i try to remove specific alert one by one ...i didn't find any thing in order to clearone thing at a time , i rightclick the alert in control center GUI..i tried close and refreshoption , still those not working to remove the specific alert entry..how to acomplish this ??thank you,-PctechMessage was edited by: pctech321

Host Systems

Was this post helpful?