Unsolved
1 Rookie
•
13 Posts
2
43899
August 22nd, 2020 15:00
Error 2000-0333
- I ran a bios diagnosis, the results said that I had failing component and that the error code was 2000-0333 and the validation was 107002. My service tag is: . Please help me solve this issue because I need my laptop for online classes very soon.
No Events found!
ejn63
10 Elder
•
30.2K Posts
0
August 22nd, 2020 15:00
This simply means you ran the graphics test without responding to the required input (Y/N after each screen).
If everything other than that is OK, re-run the tests and respond when prompted.
If there's something preventing you from seeing the test screens, that's another matter.
ejn63
10 Elder
•
30.2K Posts
0
August 22nd, 2020 16:00
Unplug the system, disconnect the battery and hold the power button for 30 sec. Try powering up thereafter.
What model system is this (N5110, 3552, etc.)?
just a human
1 Rookie
•
13 Posts
0
August 22nd, 2020 16:00
@ejn63 I changed the cmos battery and I briefly came on that when I was able to run the test. Then it booted Into windows and I tried to download a bios update, it was almost done but when it was time to reboot, the screen didn't turn on and I was getting 2 ambers and 1 white. Then I opened it back and disconnected the battery and removes the cmos battery again and tried to book up only for the screen to not turn on and I was getting 2 ambers and 5 whites now.
just a human
1 Rookie
•
13 Posts
0
August 22nd, 2020 17:00
Inspiron 15 5575
bharatpatelunjha
5 Posts
0
September 25th, 2021 01:00
hellp
Edwardmusayev
1 Rookie
•
10 Posts
0
November 6th, 2023 07:50
@ejn63 I have a question but what if the laptop booted by himself giving this error because I was going out and after I came home my laptop was beeping
BrandsHatch
1 Rookie
•
1 Message
0
December 14th, 2024 10:28
I too have this problem except that it is not possible to respond with "y" or "n". the keyboard seems to be disabled as it is not possible to abort the test either. the graphics seems to be working properly is as much as I can see the bands and subsequently the single colour full screen displays.
Machine is Lattitude D430 (EU870D)
PS; the start-up states that the diagnostic has been selected. I did not select this therefore must assume that this change in boot is a part of the problem.
(edited)