This post is more than 5 years old
2 Intern
•
157 Posts
1
7913
May 17th, 2016 14:00
isi_netlogger syntax
I've looked through the CLI guide for 7.2 and cannot find this command listed at all. There is no man page either. When I run this on our NL400 it doesn't capture anything in or out of the 10gig interfaces, only the management ports. Is this expected?
What I am trying to do is just capture traffic out of all 3 nodes on the 10gige-1 interfaces, not all the others. There is no LACP in play.
I tried using the isi_for_array with tcpdump on them but it complained about invalid interface names yet I could run tcpdump against a single if with the same syntax. Makes no sense to me.
thanks
No Events found!
Yan_Faubert
117 Posts
0
June 16th, 2016 05:00
This bug is currently in "backlog" and not tagged to a specific release. I'd recommend you talk to your account team or get an SR going to increase visibility of this issue.
Yan_Faubert
117 Posts
0
June 16th, 2016 05:00
bug# 101003.
dynamox
9 Legend
•
20.4K Posts
0
June 16th, 2016 05:00
do you have the bug ID that i can give to my SE ?
Peter_Sero
4 Operator
•
1.2K Posts
0
June 16th, 2016 20:00
Have you tried feeding the vlan id to tcpdump as an extra filter argument rather than via the -i interface option:
isi_netlogger -p -- vlan VLANID
==> /usr/sbin/tcpdump -U vlan VLANID and not arp
-- Peter
dynamox
9 Legend
•
20.4K Posts
0
June 17th, 2016 07:00
Peter,
i just tried that, while it runs it's not collecting any data. I let it run for a while, then control+c. Open the bundle file and it's empty, no capture file.