Unsolved
This post is more than 5 years old
8 Posts
0
830
March 1st, 2019 06:00
Can computrace be activated via script / command line?
Command Configure has --Computrace listed as an option with Activate / Enable being the parameters. However, right below that it says Command Configure cannot configure Computrace. CCTK also has the same options but the output is;
cctk --Computrace=Enable
or
cctk --Computrace=Activate
"Attempt to write read-only parameter "Computrace".
cctk --Computrace
"The option 'Computrace' is not available or cannot be configured through this tool."
(So why have it in their to begin with?)
Can computrace be activated remotely via script / command line?
No Events found!
iskyfly
8 Posts
0
March 1st, 2019 09:00
jphughan
9 Legend
•
14K Posts
0
March 1st, 2019 09:00
What is the current state of the Computrace setting on that box? Computrace has 3 states: permanently enabled, permanently disabled, or not configured. If it's already in either of the first two states, then you won't be able to change it to anything else.