Unsolved
This post is more than 5 years old
1 Rookie
•
55 Posts
0
2797
August 29th, 2016 12:00
Alienware Thermal Controls - Aurora R4 Windows 10
Is anyone else having their thermal controls crash on an Aurora R4 running Windows 10? I never had this issue before and have started running into it recently. When the thermal controls crash, it causes everything to crash.
Any assistance?
No Events found!
KanesInferno4
1 Rookie
•
55 Posts
0
August 29th, 2016 15:00
My command center is showing the wrong temperatures under active thermals...It shows sensor 3 was 65 degrees celsius, sensor 1 goes between 0 and 22 and sensor 2 stays at 0. This could explain why it's crashing. It was working fine until about a week ago. and that's when the crashing started. At that time the temperatures showed fine.. I decided to uninstall and download 3.6 from Dell and did a fresh install..it now is doing the weird temperature thing. Also, now the fans all show 22% and don't change RPMs..
raysz
2 Intern
•
165 Posts
0
August 30th, 2016 05:00
Yes I Had a problem with mineWhen I switch to Windows 10.. I uninstalled the command center and then reinstalled after that I had no more issue
KanesInferno4
1 Rookie
•
55 Posts
0
August 30th, 2016 07:00
And just like that the sensors are back to showing the wrong temps.. The thermal controls crashed and when re-opening it the sensors are off.
KanesInferno4
1 Rookie
•
55 Posts
0
August 30th, 2016 07:00
Well, now they're showing the correct temps again, after several uninstalls and reinstalls. I'm still worried I'll run into the crash issue, so I've just been leaving command center open at all times, so the thermals are running there...The issue was they'd crash while I'd be gaming and command center was closed. Hopefully leaving it open will prevent the crash..