Unsolved
This post is more than 5 years old
1 Message
0
6692
December 28th, 2000 23:00
Direct Memory Access Controller
My Device manager shows a conflictwith the
Direct Memory Access Controller as follows:
Device Status
"The VDMAD.VXD device loader(s) for this device could not load the device
driver
(Code2)
To fix this,click Update Driver to update the device driver."
When I did that Windows searched for and installed the driver.After rebooting
the same message appeared,and when I tried again to install the
driver,Windows
said, the driver is already installed.But the device manager still shows the
conflict.
Any ideas???
0 events found
No Events found!
DELL-Cody
2 Intern
•
2.2K Posts
0
December 29th, 2000 00:00
Has there been any software recently installed on the system? Have you attached any peripherals to the system, or installed any expansion cards? If so, first clear the NVRAM.<ADMIN NOTE: Broken link has been removed from this post by Dell>Then, boot into Safe Mode and go to START | SETTINGS | CONTROL PANEL | SYSTEM | Device Manager. If there is an Other Devices category, double click it and remove all devices listed underneath this category. Also, remove the Direct Memory Access Controller entry. Click Close, restart, and allow Windows to boot normally.