Unsolved
This post is more than 5 years old
2 Posts
0
4605
May 15th, 2003 12:00
Planar Board
I purchased a Dell Dimension 350Vxxx in 1998. I have recently moved the motherboard form the original Dell case to a new case. The new configuration does not boot, I believe it is due to the front pannel control pins. I cannot find any documentation on the Planar Motherboard apart from a graphic on the system board, however this does not provide the exact identity of each set of pins for the control pannel connector (J9G2). The part number on the board is 6328C. Does anybody have any recommendations on where I can find documentation on either the board or the front pannel pins?
Thanks,
Bernd
No Events found!
DELL-Jesse L
Moderator
•
17.9K Posts
•
69K Points
0
May 15th, 2003 12:00
bleger,
Thank you for using the Dell Community Forum.
That information is not availble in my database.
DELL-Jesse L
Moderator
•
17.9K Posts
•
69K Points
0
May 15th, 2003 12:00
bleger,
The make of the monterboard is Intel. The boards are made specifically for Dell boxes. I doubt you can get any information from their site but, you can try. www.intel.com.
bleger
2 Posts
0
May 15th, 2003 12:00
Jesse,
Can you point me to Planar's support site, so I can see if they have any additional information?
Thanks,
Bernd
Malinthas
250 Posts
0
May 15th, 2003 14:00
Bleger-
Your best bet may be just to post around until you find somebody with the same MoBo, and ask them to look at their configuration. Try every board you can hit... somebody else out there has to have one.