Unsolved
This post is more than 5 years old
2 Posts
0
6462
March 18th, 2002 16:00
Plug & Play Configuration Error
When the GX50 boots, I get the following message:
Plug & Play Configuration Error
Strike F1 key to continue, F2 to run the setup utility.
If I strike F1, the system continues to boot normally and everything seems to work fine. There is some sort of PCI hardware that the system wants to install and can't, called "PCI Simple C___ Controller"
What do I need to do to make this message go away. I think the system is functioning well
Plug & Play Configuration Error
Strike F1 key to continue, F2 to run the setup utility.
If I strike F1, the system continues to boot normally and everything seems to work fine. There is some sort of PCI hardware that the system wants to install and can't, called "PCI Simple C___ Controller"
What do I need to do to make this message go away. I think the system is functioning well
No Events found!
DELL-Stephen S
2 Intern
•
1.4K Posts
0
March 20th, 2002 20:00
Thank you for visiting DELLTalk.
The first thing that I would recommend trying is to clear the NVRAM (see below) and see if you still get the same message. If so, try removing any added hardware from the system to restore the original system configuration, clear the NVRAM and then restart to see if you are still getting the same error message.
If the problem persists, please contact Dell Technical Support via e-mail for personalized assistance.
You can find information on clearing the NVRAM on most newer OptiPlex systems in the Dell Online Knowledge Base article located here.
Karl Weyers
2 Posts
0
March 21st, 2002 17:00
DELL-Stephen S
2 Intern
•
1.4K Posts
0
March 22nd, 2002 18:00
No problem, glad to hear that this was of some assistance.
Thank you for visiting DELLTalk.
Nashvegas-TN
2 Posts
0
September 26th, 2006 15:00