Unsolved
This post is more than 5 years old
6 Posts
0
5858
June 30th, 2005 16:00
Slow starting 4100
The hardware is a Dell 4100 933mhz 256mb ram and 20gb generic IDE disk drive (type 47) I have a CD_R and a CD_RW. I am currently running the following: Win Me 4.90.3000, IE 5.50.4807.2300 with my trusty Outlook Express .50.4807.1700. My startups are ZA 2.6.362, Spyblocker 5.0 and AVG 7.0.308. As my subject implies header implies when I first boot-up the OEM logo stays up for about 45 seconds. Normally it flashes by so quickly it is barely seen. When I run boot analyzer
http://www.woundedmoon.org/win32/bootloganalyzer123.html and sort by duration the items that delay the most are these
11:31:14 0.28 Loading PNP drivers of Creative Sound Blaster AudioPCI 64V (WDM) (PCI\VEN_1274&DEV_1371&SUBSYS_13711274&REV_09\60F000
11:31:16 0.00 Dynamic load failed : [000B640E] File not found
11:31:20 1.33 Initing esdi_506.pdr
11:31:21 0.28 Init Success esdi_506.pdr
11:31:22 0.28 Dynamic load success C:\WINDOWS\system\serial.vxd
11:31:22 1.28 INITCOMPLETE = AVGCORE
11:31:24 5.17 InitDone = TSRQuery (time estimated)
11:31:29 9.56 Enumerated Standard Floppy Disk Controller (ACPI\*PNP0700\0)
11:31:39 16.06 Enumerated Microsoft Kernel Audio Mixer (SW\{B7EAFDC0-A680-11D0-96D8-00AA0051E51D}\{9B365890-165F-11D0-A195-0020AFD15
11:31:16 0.00 Dynamic load failed : [000B640E] File not found
11:31:20 1.33 Initing esdi_506.pdr
11:31:21 0.28 Init Success esdi_506.pdr
11:31:22 0.28 Dynamic load success C:\WINDOWS\system\serial.vxd
11:31:22 1.28 INITCOMPLETE = AVGCORE
11:31:24 5.17 InitDone = TSRQuery (time estimated)
11:31:29 9.56 Enumerated Standard Floppy Disk Controller (ACPI\*PNP0700\0)
11:31:39 16.06 Enumerated Microsoft Kernel Audio Mixer (SW\{B7EAFDC0-A680-11D0-96D8-00AA0051E51D}\{9B365890-165F-11D0-A195-0020AFD15
Has anyone experienced the Dell logo just sitting on the monitor? If so what did you do about it?
Along with this my CD-r and CD-rw are not recognized by my computer. I don't know if this is related. When I boot from a floppy I get these messages
Diagnostic tools were successfully loaded to drive D
Device driver not found: 'MSCD001'
No valid CDROM device drivers selected.
Has anyone else had this happen and what did you do to solve it?
Thank you
Rita
No Events found!
osprey4
6 Operator
•
34.2K Posts
0
June 30th, 2005 18:00
Rita:
Boot to system setup and see what CD devices are reported under IDE configuration. While there, try resetting the config data (change to Yes). Also, if it's not set, change your boot option to quick.
Post back and let me know what happened.
Bobman101
693 Posts
0
June 30th, 2005 18:00
I'm not certain about the other problem though.
Ritalu
6 Posts
0
June 30th, 2005 21:00
Thank you for your reply. Under IDE configuration I have IDE controller selected to both. The primary IDE master is Maxtor. All other IDE items are "not installed". I reset the config data to yes. The boot option was set to "quick and quiet". I am still getting the Dell logo. The boot order reads as follows:
1st Boot device Floppy
2nd boot device ARMD-FDD
3rd boot device IDE-HDD
4th atapi cdrom
5th disabled
Rita
Message Edited by Ritalu on 06-30-2005 05:06 PM