19' 1908B-BLK Flat Panel Display - Stand question

Question

I purchased a refurbished one, which arrived with the stand attached and the monitor fully extended to the top of the stand.  Unlike the newer models, there is no  locking/unlocking button on the back of the stand, though there are the 2 vertical groves on the inside of the stand that seem to indicate it can be moved up and down.   How do I adjust the height of the monitor on the stand?   I looked at the manual for the 1908FP and it clearly says the height can be adjusted up and down, but it doesn't say how.   I don't want to attempt to force the mechanism  by pushing on it unless I know for sure that's how it's done.  Don't want to break it!

DELL-Chris M · Answer

sfphil, I would remove the panel from the stand and then try to slide the stand up and down. It might just be stuck.

sfphil · Answer

Thanks - you're right - it was just stuck at the top.  After experimenting I found the right way to apply pressure to move it up and down.  Works fine now.

Monitors

Was this post helpful?