Unsolved
This post is more than 5 years old
2 Posts
0
3851
July 9th, 2009 21:00
19" 1908B-BLK Flat Panel Display - Stand question
I purchased a refurbished one, which arrived with the stand attached and the monitor fully extended to the top of the stand. Unlike the newer models, there is no locking/unlocking button on the back of the stand, though there are the 2 vertical groves on the inside of the stand that seem to indicate it can be moved up and down. How do I adjust the height of the monitor on the stand?
I looked at the manual for the 1908FP and it clearly says the height can be adjusted up and down, but it doesn't say how. I don't want to attempt to force the mechanism by pushing on it unless I know for sure that's how it's done. Don't want to break it!
0 events found
No Events found!
DELL-Chris M
Community Manager
•
56.9K Posts
•
232.1K Points
0
July 10th, 2009 07:00
sfphil,
I would remove the panel from the stand and then try to slide the stand up and down. It might just be stuck.
sfphil
2 Posts
0
July 11th, 2009 09:00
Thanks - you're right - it was just stuck at the top. After experimenting I found the right way to apply pressure to move it up and down. Works fine now.